Follow My Carving - Gnarly Tree

Follow this Gnarly Tree carving as it
progresses to final form. Use the
links to the right or at the bottom
of the page to see each step.

Step 10 Now that the trunk has a little bit of shaping, the knot hole can be made.

A flat gouge is held at an angle and the edges are defined. The center is scooped out with a micro gouge. Then, the middle area is flattened with the straight gouge and the process is repeated one or two more times. The result is a rather dimensional knot.

In the next installment the limbs are shaped.

Step 1 | Step 2 | Step 3 |  Step 4 | Step 5 | 
Step 6 | Step 7 | Step8 |  Step 9 | Step 10 | 
Step 11 | Step 12 | Step 13 |  Step 14 | 
Step 15 |  Step 16 | Step 17 | Step 18
Step 19 | Step 20 | Step 21 |  Step 22 | 
Step 23 | Step 24 |